Bafo BF-2010 User Manual download pdf (Page 2)

Serial Cable Pinout For Low-Speed Data Port

RJ-22 Serial connection

If your receiver has a low speed data port on it then you should build your serial cable as

indicated below. Note that the modular connector required is a RJ-22. This is the smaller

modular connector that is used on telephone handset cords. This connector requires a special die

in your crimper. A RJ-11/14 crimper will not work if you attempt to crimp a RJ-22 plug with it.

USB connection

The module supports serial control via a USB port for all other receivers. This module was tested

with an IOGEAR GUC232A. DirecTV has also listed the ATEN UC-232A and the BAFO BF-810 as

being compatible with the USB port on the receiver. Please note that you must power cycle

the receiver after plugging in the USB dongle in order for the USB driver to load. Using

the red reboot switch will not load the driver. Also note that the LED on the dongle will not

illuminate. When using a USB dongle you must pin your serial cable pin 2 to pin 3, pin 3 to pin 2

and pin 5 to pin 5. Pins 1,4,6,7,8 and 9 should not be connected in your cable.

DirecTV SonicTap Music v3 ControlWorks Consulting, LLC

Telephone: (+1)440-449-1100 [email protected] http://www.controlworks.com

1 2 3 4 5 6 7 8 9

No comments

Bafo BF-2010 User Manual Page 2